Harry's GPS Suite Forum

Hello Harry,

I want to ask. Today we were on track and strange thing happened. We did physicaly 10 full laps, but in Laptimer, there is only 9 and 2 are merged into "one". This happened after 2 laps (1,2 are ok, 3,4 are merged and 5-10 are OK again) How is it possible? Can I somehow separate them? It never happened before

This means the s/f trigger has been missed for one lap. This typically occurs when GPS accuracy is too low / disturbed. You can split this “multi-lap” as follows: select it from Lap List, follow Data Recordings / Fixes, select Verify Lap from the pop up list shown for the second icon in the bottom.

Select “Wide” when asked and agree to purge the multi-lap once it has been split. In case it isn’t split, enlarge the Wide corridor in Expert Settings and try again.

Harry