Harry's GPS Suite Forum

Posted: **Sun Sep 28, 2014 3:06 pm**

Harry,

I was testing again with the road rally configuration (v18.3.3, iPhone 4s, iPad, XGPS160) and the standing go gap in timer view on the iPad was nan (not a number). When I started, nan was immediately displayed. Sorry the photo is upside down!

: HLTNAN.jpg (103.43 KiB) Viewed 1631 times

Also, both the iPhone and iPad became disconnected to the XGPS160. I suppose this is something I should address with Dual, correct? Have you heard of other reports of losing the connection? Any tests you might suggest I run?

Deven

Posted: **Sun Sep 28, 2014 3:56 pm**

nan = not a number
This means LapTimer cannot calculate the gap for some mathematical reason. Is this on your rally and are you "one track"?

- Harry

Posted: **Sun Sep 28, 2014 4:16 pm**

Yes, I was testing on a local highway. I have used this rally track and reference lap before without any problem. My iPhone, which was configured exactly the same, started fine.

Deven

Posted: **Sun Sep 28, 2014 4:19 pm**

So you are driving on a completely different route compared to the reference lap?

- Harry

Posted: **Sun Sep 28, 2014 6:11 pm**

No, track and reference lap are consistent. The track covers a stretch of local highway and the reference lap is spreadsheet generated and follows the track.

Deven

Harry's GPS Suite Forum

Timer view gap is "nan"

Timer view gap is "nan"

Re: Timer view gap is "nan"

Re: Timer view gap is "nan"

Re: Timer view gap is "nan"

Re: Timer view gap is "nan"