Circuit Tools - Most Basic Question
-
fbamber@gmail.com
- Fewer than 10 Posts
- Posts: 1
- Joined: Sat Oct 13, 2012 4:30 pm
Circuit Tools - Most Basic Question
I loaded my e-mailed .vbo file. Everything was blank except summary information on the whole session. What I have done wrong?
-
Canyonfive
- Fewer than 10 Posts
- Posts: 8
- Joined: Wed Oct 10, 2012 12:19 am
Re: Circuit Tools - Most Basic Question
Mine dont show up until i go into the start finish wizard and reclick on the start and finish and adj the gate width as needed
Re: Circuit Tools - Most Basic Question
The problem with CT is it makes it's own decision where laps start and stop. It treats LapTimer data as raw data and starts a lap / split detection process again. As the detection process is obviously a different one than that of LapTimer, it sometimes works directly, and needs some gate width (and other) adjustments in other cases.
- Harry
- Harry
