Page 1 of 1
Circuit Tools - Most Basic Question
Posted: Sat Oct 13, 2012 6:39 pm
by fbamber@gmail.com
I loaded my e-mailed .vbo file. Everything was blank except summary information on the whole session. What I have done wrong?
Re: Circuit Tools - Most Basic Question
Posted: Sat Oct 13, 2012 6:51 pm
by Harry
Maybe you lap had no data? Did you have a look into it?
Re: Circuit Tools - Most Basic Question
Posted: Tue Oct 16, 2012 12:58 am
by Canyonfive
Mine dont show up until i go into the start finish wizard and reclick on the start and finish and adj the gate width as needed
Re: Circuit Tools - Most Basic Question
Posted: Tue Oct 16, 2012 7:29 am
by Harry
The problem with CT is it makes it's own decision where laps start and stop. It treats LapTimer data as raw data and starts a lap / split detection process again. As the detection process is obviously a different one than that of LapTimer, it sometimes works directly, and needs some gate width (and other) adjustments in other cases.
- Harry
Re: Circuit Tools - Most Basic Question
Posted: Thu Nov 08, 2012 9:50 am
by Harry
Please check this article:
viewtopic.php?f=8&t=974
- Harry