Harry's GPS Suite Forum

I do not understand what happened…at an Autobahn track day Laptimer developed a mind if its own. It started and stopped over 100 time, some in grid and some on course. Analysis said I ran 132 laps, some at over two hundred MPH in less than 2 minutes, on a track just a little less than 4 miles. I only ran two 20 minutes sessions due to brake failure. I have only two completely recorded runs.
Additionally, when I tried to overlay the data was there, but the video could not be retrieved.
And going back to a previous question, I still cannot get the complete track image on the runs that do record. I have turned Dynamic view off and on to the same result.
Additionally, I cannot load the app on my desktop PC, message indicated I have it on two phones and will not give me an option for the PC.
The app once worked fine, what could have happened?

Thanks,
Bob L.

The false starts detected as well as the high speed "measured" indicate there has been a problem with GPS accuracy. Had you mounted the device like shown in illustration #3 of LapTimer's Quick Reference? Furthermore, please make sure

• you have not checked "Allow Low Speeds" in LapTimer ‣ Administration ‣ Settings ‣ Expert Settings ‣ Trigger Detection
• you see no warning on track set conflicts; in case you do, reload the track set you are driving and allow LapTimer to purge the conflicting track set when it asks you

- Harry