Holux 1000C - Setting 10hz?
Posted: Mon May 28, 2018 4:22 pm
Hi all,
I have a Holux 1000C BT GPS (MTK3329 based) which is capable of 10Hz update rates.
By default the GPS is set to 1Hz, and LapTimer reports it as being "connected @ 1Hz".
Can i use the "initialization expert setting" to send the NMEA command to set a different update rate?
The MTK manual says sending "$PMTK220,100*2F" will set a 10Hz rate.
Ive tried entering this in that settings line, but seemed to have no effect.
Any help?
Thanks.
I have a Holux 1000C BT GPS (MTK3329 based) which is capable of 10Hz update rates.
By default the GPS is set to 1Hz, and LapTimer reports it as being "connected @ 1Hz".
Can i use the "initialization expert setting" to send the NMEA command to set a different update rate?
The MTK manual says sending "$PMTK220,100*2F" will set a 10Hz rate.
Ive tried entering this in that settings line, but seemed to have no effect.
Any help?
Thanks.