Harry's GPS Suite Forum

Harry,

1. Is there any way to overlay an entire session of laps rather than one lap at a time?

2. When I come in from a session, I press Cancel to stop HLT. Can I overlay that last partial lap which doesn't show up on the lap list?

3. Can I export the entire raw video from the session?

4. HLT was capturing video on my iPhone 6 during a session and then stopped midway through (and not at the Start/Finish, non video functions continued normally). Any idea what might have caused this?

Thanks,

Deven

1. Start with a single lap overlay. In the Overlay Configuration screen you can expand the range to a full session.
2. No, data recordings for cool down laps are purged
3. See 1, yes.
4. Incoming calls, or notifications using Alerts (instead of Banners); workaround: switch any Alert notification to Banner in iOS Settings

- Harry

When I overlay an entire session (15-20 min, 4-6 laps), I find that the OBD data (speed, rpm) sometimes freezes midway through. If I process lap by lap, it works. v18.3.7 GP. iPhone 6, 8.1.1, 128GB with plenty free.

Deven

Sure? There has been an issue with freezing data (not only OBD, but everything except time) for lap 2 lap transitions in earlier versions, but not in the most recent. Can you please try to reproduce this behavior for a small set of data (e.g. two consecutive lap) and export these laps to .hlptrl and send it to me?

- Harry

I sent you the lap data. Same problem with two consecutive laps. This was also the session where HLT stopped recording video part way through a lap.

Deven