Harry's GPS Suite Forum

So you mean:

1. Pull out OBD dongle from car
2. Start HLT - expert settings - set PID 3 adaptive.
3. Start logging only for OBD Sensors
4. Start engine, put in dongle and wait for connection
5. After connection, In sensors list check available PIDs (and make screenshots)
6. Don't rev engine? Keep it on idle? Don't push throttle pedal
7. How long i must wait before finish logging?

Everything correct except the rev'ing. Please test some throttle positions so the range of values delivered is getting bigger than the range we have seen before.

Please log something between 30 and 60 seconds once the connection has been established.

Harry

Ok i will try it

Email on the way