Lap starting 1+ Sec behind start/finish line
Posted: Tue Aug 04, 2020 8:38 pm
I've been struggling for a few hours trying to just sync the video with the start/finish line and the actual laptimer.
I set up a session (13x laps) and ensured the video was in sync crossing the finish line, and had that set for the entire session.
When i go to the video however, the lap starts already with 1.34secs on the clock.
I assume this has something to do either video or gps or obd update.
i've played around with expert mode and the video delay settings but can't seem to get it right.
in addition, the gears and rpms seem all out of whack eventhough i double checked all the settings for the vehicle setup (secondary - just want to get video correct)
Any ideas? am i on the right path but just need to keep tweaking things within the video and sensor delays?
I'm using:
iphone 11 Pro
GoPro Hero 7 Black
XGPS160
KIWI OBD
Thanks,
Colin
I set up a session (13x laps) and ensured the video was in sync crossing the finish line, and had that set for the entire session.
When i go to the video however, the lap starts already with 1.34secs on the clock.
I assume this has something to do either video or gps or obd update.
i've played around with expert mode and the video delay settings but can't seem to get it right.
in addition, the gears and rpms seem all out of whack eventhough i double checked all the settings for the vehicle setup (secondary - just want to get video correct)
Any ideas? am i on the right path but just need to keep tweaking things within the video and sensor delays?
I'm using:
iphone 11 Pro
GoPro Hero 7 Black
XGPS160
KIWI OBD
Thanks,
Colin