Lap timer - using AutoX for Hill Climbs
Posted: Mon Jun 24, 2019 11:10 am
Hello everyone this is my first post. I use Laptimer grandprix for the first time at the Prescott Hill Climb on Saturday.
I have a problem setting up the course and, as I will be at Gurston Down Hill Climb in August wnated some advice.
So, after attaching my Dual XGPC160
1 Select Race Setup
2. Select AutoX +
3. Rename
4. Walk to start, set start and set as standing start
5. then walk to finish
The wlak up a hill climb course takes some time and each time I tried to do it while walkiung the course it crashed. The only way I got a finish point sorted was byt joggin up the hill directly and crossing over fences to get there.
Is there a 'time out' running during set up?
At Gurston there are no short cuts so I can't see how I can set up a fnish in time.
Is there a way of manually setting it up?
ONce set up it worked fine. Time recorded was witing 0.5s of the official time whcih I though was excellent.
Film really good too.
Thanks for your help !
Snowy
I have a problem setting up the course and, as I will be at Gurston Down Hill Climb in August wnated some advice.
So, after attaching my Dual XGPC160
1 Select Race Setup
2. Select AutoX +
3. Rename
4. Walk to start, set start and set as standing start
5. then walk to finish
The wlak up a hill climb course takes some time and each time I tried to do it while walkiung the course it crashed. The only way I got a finish point sorted was byt joggin up the hill directly and crossing over fences to get there.
Is there a 'time out' running during set up?
At Gurston there are no short cuts so I can't see how I can set up a fnish in time.
Is there a way of manually setting it up?
ONce set up it worked fine. Time recorded was witing 0.5s of the official time whcih I though was excellent.
Film really good too.
Thanks for your help !
Snowy