HelpMotorbikePreset.png (32.37 KiB) Viewed 2226 times
This means the device needs a tilt of 70 degree (90 degree would be flat). Both portrait or landscape orientation is fine. Please make sure your current vehicle has a "Motorbike" type set so LapTimer switches over to Motorbike Preset automatically (or set it directly in Settings).
Okay then my setup is probably very close to exact.
My lapping data says it's using the motorbike mode but I'm still not getting lateral force data. Unfortunately I've already recalculated all of the sessions so I don't have anything to share.
That's what I have been doing. Will it still record if it doesn't calibrate first? I only ask because it records but I'm definitely not getting an accurate reading for lean angle. It only shows lean for the very middle of the corner. That's why I've still been using the GPS data instead of the accelerometer meter data.
Calibration is one approach to find a correct setting, a Preset is the other. Please don't mix that up. If you get a lean in the center of the corner only - probably where you have most lean, this is a clear signal the device is not at 0 acceleration while standing still (i.e. you do not have it mounted at 70 degree tilt). You can verify you have the correct angle by mounting the device and have a look into the acceleration shown while standing still. If lateral and lineal is 0 (+-0.05), you are at 70 degree. In case you have more, adjust the angle.